Mark E Quick-Pitch Standard Float Sticks -- 4 Standard 36" Float Sticks
The Quick Pitch Float Stick System for easy construction of shower floors
Eliminates the need for measurements or levels to achieve a properly sloped shower floor
Includes 4 Standard Float Sticks Only
Note: Quick-Pitch Sticks do not attach to the Pre-Pitch system
Mark E Quick-Pitch Standard Float Sticks
- The Standard Sticks can be used in standard 36" x 60" shower areas with a centered drain, or custom shower areas where the drain is within 36" of each wall
- Creates with the proper minimum water drainage slope of 1/4" per 12" run
- Attach the tapered Float Sticks (1" to 1-3/4" taper x 36" long) to the Center Ring to assure the correct drainage slope
- Use in standard or custom shower areas with walls up to 36" in any direction from the floor drain
- This system does not add to the pan liner preslope as the Center Ring sits on top of the drain flange bolts
Previous Posts
End Cap for Schluter TREP-SE/-S
Dural Duraplus Box Section Transition Profiles Aluminum Anodized
Rubber Insert Replacement for Schluter DILEX-KSN
Dural Durosol Square Edge Profile Aluminum Beige Powder Coated
Inside Corner for Schluter RONDEC-STEP
Schluter DITRA-HEAT-E-RS Non-Programmable Thermostat
End Cap for Schluter DILEX-EHK/-HKS
Schluter DECO Tile Edge Protection / Decorative Profiles
Dural Durosol Square Edge Profile PVC Beige
Inside Corner for Schluter DILEX-AHKA
Dural Duralis Listello Deco Aluminum Profiles 1 Inch
Dural Duralis Listello Deco Brushed Stainless Steel Profiles
Schluter BARA-RTP Balcony Gutter System Edging Profiles
Mark E StringA-Level Wall Tile Installation Bubble Level Case
Mark E Pre-Pitch Shower Sub Floor Slope Pitch Standard Kit